Danfoss FlatStation Heat Interface Units are suitable for small one bedroom apartments up to major commercial applications.
Please contact us for design, sizing and selection.
In this table you will see all the relevant key data for the HIU product range:
|DHW and direct heating
|DHW and indirect heating
|Floor standing or wall mounted for high loads
Danfoss FlatStations go through comprehensive quality assurance and are built to standards that adhere to ISO/TS 16949:2009 (Quality management system requirements for the design and development, production and, when relevant, installation and service of automotive-related products). Danfoss FlatStations are the tried, tested, and trusted solution within UK, due to it standing the test of time in Denmark, a country with decades of heat network experience and knowledge.
The most important design objective for a 4G Heat Network (HN) is to consistently achieve low return temperatures under all operating conditions. To accomplish this, the heat interface units (HIUs) must demonstrate expert control of pressure, flowrate, heat transfer and temperature. Danfoss regard these four competencies as their DNA.
Danfoss FlatStations are easy to install, commission and service. They require no specialised equipment to set-up and begin delivering heat efficiently and reliably to the consumer.
Whether from the initial brief and employers’ requirements (ER), to detailed design, commissioning, and handover, to ongoing operation and site support.
Have a question?
If you would like to talk to us directly, please call or send us an inquiry!